WATERFALL POS ASSEMBLY

Before you build

LAY IT ALL OUT

Put every piece on a flat surface and check that everything is there. The parts should slot together neatly when they are facing the right way.

Backing board

Middle locking shelf

4 dividers

Top shelf

Clear shelving units

Locking pin

Something missing? Pause here before you start.

One step at a time

LET'S BUILD IT

Use the photos as your orientation guide. Nothing needs to be forced.

The Waterfall POS stand parts laid out on a flat surface

LAY EVERYTHING OUT

Find a clear, flat surface and place every part where you can see it. Match what you have against the parts check above.

ATTACH THE DIVIDERS

Slide the angled slot on each of the four dividers into the middle locking shelf. They should settle into place when the angles line up.

TIP: Turn the shelf vertically and stack the dividers as shown. It is much easier.

The dividers sliding into the middle locking shelf

The top shelf being fitted to the Waterfall POS stand

FIT THE BACKING BOARD & TOP SHELF

Slot the backing board onto the dividers. Slide in the top shelf so it rests neatly in place. If your stand includes a custom backboard, add it now, then secure everything with the locking pin.

The locking pin being slotted into the assembled stand

A custom backboard being fitted behind the top shelf

ADD THE CLEAR SHELVES

Peel the protective film from the clear shelving units, then slot each shelf into the dividers.

Yes, peeling the film is oddly satisfying.

A finger pointing to the peel-to-remove protective film label on a clear shelf

The clear shelving units being installed on the Waterfall POS stand

The completed Little & Wood six-SKU Waterfall POS stand filled with products

LOAD IT UP

Your stand is ready. Add your Little & Wood kits, give the display a quick straighten and start MAKING FUN.

Quick fixes

TROUBLESHOOTING

Most assembly hiccups come down to orientation or one piece not being fully slotted in.

A piece does not fit

Check that every part is facing the right way and that the slots meet at the angles shown. If a piece resists, stop and reposition it rather than forcing it.

The stand feels wobbly

Check that each part is fully slotted into place, especially the middle locking shelf, top shelf and locking pin.

How do I clean it?

Wipe the stand with a soft, lightly damp cloth. Avoid soaking the wooden parts or using abrasive cleaners.

I think a part is missing

Pause the assembly and contact us with a photo of the parts you received. We will help you identify what is missing and get it sorted.

READ THE VIDEO SUMMARY

Lay out every part before you start. Fit the four dividers into the middle locking shelf, add the backing board and top shelf, secure the stand with the locking pin, then add the clear shelving units. If anything resists, stop and check its direction rather than forcing it.

Need a hand?

STILL STUCK?

Send us a photo and tell us which step you are up to. We will help you get it sorted.

BUILD YOUR STAND